CJ 4 – Waterborne Spray Booth

The CJ 4 is designed for the use of water based paints instead of solvent based paints.

Description	Data
External Dimensions	7 000 mm (L) x 5 650 mm (W) x 3 500 mm (H)
Internal Dimension	6 900 mm (L) x 3 900 mm (W) x 2 650 mm (H)
Entrance Dimensions	3 000 mm (W) x 2 600 mm (H)
Personnel Door Dimensions	800mm (W) x 2000mm (H)
Structural Material	Manufactured from 50 mm Polyurethane Insulated Panels
Lighting System	Ceiling: 8 Fittings: Each 4 x 58 W Tubes Side Lights: 8 Fittings: Each with 4 x 36 W Tubes LED is Optional
Airflow Volume	25 000 m³/hour
Total Power Consumption	22 kW
Power Supply	380V / 50 Hz / 3 Phase
Electrical Control System	Included
Ducting	5m Straight Lengths with 1 x Exhaust Bend
Floor Basement	Galvanized Steel 300 mm (H) Full Floor Grids with Floor Filters 2 x Ramps: 900mm (W) x 2000mm (L)
Air Generation System Location	Left, Right or Rear – Client to specify (Right by Default)
Intake Fan	2 x 4 kW Centrifugal Fans – Belt Drive
Extraction Fan	1 x 7.5 kW Centrifugal Fan – Belt Drive
Baking Heating System	Riello RG5S Diesel Burner @ 260 000 Kcal/Hr
Operating Temperature	60 °C – 80 °C
Water Bourne Drying System	3 x 0.75 kW Fans @ 4800 m³/h – Stainless Steel Nozzles
Filtration System	4 Stage: Pre-Filter, Ceiling Filter, Fibreglass Floor Filter, Activated Carbon Final Filter (Cartridge Type).
Heat Exchanger	Stainless Steel 304

The dimensions for the Waterborne Spray Booth can be changed to meet your requirements.
Additional air is induced at a higher pressure and volume, through inlets located along the sides of the ceiling.
The Waterborne System can be explained in greater detail on request
The Extraction Exhaust System for the Waterborne System is equipped with a single stage filter system driven by a double intake extraction fan.
The Waterborne Spray Booth is equipped with the required lighting on both sides along the length of the ceiling.
Additional lighting is installed along the sides of the walls and centred for enhanced lighting and added security in regards to your paint finish.
All induced air into the Waterborne Spray Booth is filtered prior to entering the intake system.
The air is induced into the Waterborne Spray Booth via the ceiling cavity which is fitted with the highest quality filter media.
The booth is placed under a positive pressure and all spray and fumes are forced downward into the false basement.
The Waterborne Spray Booth extraction system filters all exhausted air through the floor filters and ensures optimum performance and enhanced airflow, which results in increased operator comfort and a higher quality paint finish.
The booth is fitted with a baking system which is fuelled either by diesel oil or gas, depending on your preference. Additional information about the baking system can be supplied upon request.
The Waterborne Spray Booth is installed with 5m exhaust ducting. Should additional ducting be required in order to exhaust 1m above the roof level of your premises, this could be supplied as well.

CJ 4 – Waterborne Spray Booth

Enquire now

Products related to this...

CJ 3 – EU Standard for Export and For South African Municipal Approval Standards

CJ 3 – Standard Spray Booth

CJ 6 Spray Booth for Trucks and Buses

CJ 1 – Budget Spray Booth